Table of Contents
Advertisement
CAUTION: Disconnect tool from air supply before performing any service procedure.
PROBLEM
Air leaking near top of tool ar at
trigger area.
Air leaking near bottom of tool.
Tool does nothing or operates
sluggishly.
Tool jamming frequently.
Consult our on-line Technical Support site at support.primatech.ca for updated
documents and more tips.
TROUBLESHOOTING
CORRECTION
Tighten screws.
O-ring or seal worn or damaged – replace damaged
or worn components.
Check air supply.
Inadequate lubrication – Add 5 or 6 drops of oil into
air inlet.
O-rings or seal worn or damaged – replace
damaged or worn components.
Incorrect or damaged – Use approved fasteners of
correct gage and size.
Magazine or nose screws loose – Tighten all
screws.
Magazine is dirty – Clean magazine.
Replace worn or damaged driver.
Advertisement
Table of Contents
