Air Supply; Loading The Tool; Operating The Tool - primatech 534FN Operating Instructions Manual

Finish nailer

Table of Contents

Model 534FN is pneumatic framing nailer designed to install 15

lengths of 1-1/4" (32mm) to 2-1/2" (63mm). Fastener collation angle is 34°.

AIR SUPPLY

This tool is designed to operate on clean, dry, compressed air at regulated pessures

between 70 and 120 psi (4.9-8.3 bar). The preferred system would include a filter, a

pressure regulator, and automatic oiler located as close to the tool as possible, ideally

within 15 feet. All compressed air contains moisture and other contaminates that are

detrimental to internal components of the tool. An air line filter will remove most of these

contaminates and significantly prolong the life of the tool. If an in-line oiler is not available,

place about six drops of oil into the tool's air inlet at the beginning of each workday.

CAUTION: All line components (hoses, connectors, filters, regulators, etc.) must meet 150%

of the maximum system pressure. The use of a hose of ID 3/8" is recommended.

Do not connect this tool to a system with maximum potential pressure greater than 180 psi

(12.3 bar).

CAUTION:

Always connect tool to air supply before loading fasteners.

Do not load fasteners with trigger or safety depressed.

Never use a tool that leaks air or needs repair.

• Insert a strip of nails into rear of magazine then push nails forward and beyond the pusher

(Fig. 15).

• Pull the pusher to the rear of the magazine until it engages behind the fasteners (Fig. 17).

• Grasp and rotate directional exhaust deflector (Fig. 18), so that the exhaust air blast will

be directed away from the operator.

This nailer is equipped with a safety contact and will not operate unless the safety contact is

depressed against the work piece.

The 534FN can be operated in two different ways: trigger fire (single sequential) or bump fire

(contact actuation).

CAUTION: Read and understand operating manual before changing the trigger mode.

Improper use may result in serious injury.

OPERATING INSTRUCTIONS

diameter framing nails in

Table of Contents