Battery Installation; Compatible Memory Cards; Installing The Card - Lectrosonics PDR Instruction Manual

Battery Installation

The audio recorder is powered by a single AAA Lithium
battery for 6 hours of operation.
Zinc-carbon batteries marked "heavy-duty" or "long-
lasting" are not adequate.
NOTE: Although alkaline batteries will work in
the PDR, we strongly recommend that they be
used only for short-term testing. For any actual
production use, we recommend the use of
disposable lithium AAA batteries.
Push inward on the release tabs to open the door.
Insert the battery according to the markings inside the
battery compartment door. The (+) pos. end of the bat-
tery is oriented as shown here.

Compatible Memory Cards

We have tested a wide variety of cards and these performed the best
with no issues or errors.
•
Lexar 16GB High Performance UHS-I (Lexar part number
LSDMI16GBBNL300).
•
SanDisk 16GB Extreme PLUS UHS-I (SanDisk part number
SDSDQX-016G-GN6MA)
•
Sony 16GB UHS-I (Sony part number SR16UXA/TQ)
•
PNY Technologies 16GB Elite UHS-1 (PNY part number
P-SDU16U185EL-GE)
•
Samsung 16GB PRO UHS-1 (Samsung part number
MB-MG16EA/AM)
Rio Rancho, NM
Battery
polarity
markings
Press tabs to
open door

Installing the Card

The card slot is covered by a flexible cap. Open the cap
by pulling out on the side flush with the housing.
Pull up on this side of cap to open
Danger of explosion if battery is
incorrectly replaced.
Replace only with the same or equivalent type.
Portable Digital Recorder
Insert the card with the
label facing the keypad
side of the recorder.
CAUTION:
3