Introduction; General Information - BONAIRE Durango 3500M Owner's Manual

BONAIRE PORTABLE COOLER

Introduction

Introduction

General Information

Thank you for purchasing a quality Bonaire Evaporative Portable Cooler. We care about your safety and
would ask you to spend a few minutes reading these simple instructions before operating this product.
Safety!
Read carefully all of these instructions prior to operating the unit.


Read and Save these Instructions. Do not throw these Instructions away.

Complete the unit assembly before attempting to operate.

 Interference with and operation of this cooler in any manner not prescribed by these instructions could
cause a safety issue and WILL void any warranty.
 Do not use cooler on uneven or unstable surfaces.
 Use only with a 110V 60Hz single phase grounded GFCI protected electrical receptacle.
 Do not operate cooler with Rear Filter Panel removed.
 Do not use immediately adjacent to heat sources such as stoves or radiators.
 Do not use the cooler immediately adjacent to sources of water, such as swimming pools, hot tubs,
bath tubs, sinks.
 Do not operate cooler with a damaged cord, plug or other component.
 Do not run the power cord under carpet or other floor covering.
 Do not use the power cord with an adaptor plug that converts the 3 pin plug into a 2 prong connector.
 Do not use the cooler with an improperly grounded outlet.
 Do not overfill. Use water only.
 Do not alter or modify this cooler.
 Do not allow children to operate or service this cooler.
 Lock all the wheels before operating cooler.
 Do not step on or roll over power cord with heavy or sharp objects.
 Remove the plug from the electrical receptacle by pulling on the plug and not the cord.
 Never wash the unit cabinet with a garden hose: water may harm the motor and electrical system.
 WARNING: To reduce the risk of fire or electric shock, do not use this product with any solid state
speed control device.
 Use only qualified electricians for replacement or servicing of switches, or electrical motors and
components in this cooler.
 Unplug the cooler and position the rotary control knob to the OFF position when servicing or cleaning.
Page | 4