Problem Solving - BONAIRE Durango 3500M Owner's Manual

BONAIRE PORTABLE COOLER

Problem Solving

Problem So lving
PROBLEM
Unit fails to start
Filter Pads not
wetting.
Filter pads too wet
Water leaking from
overflow
Water Droplets in
air stream
Excessive humidity
Inadequate
Cooling
Unpleasant Odor
Rapid formation of
white deposits on
pads
PROBABLE CAUSE
a. Power Failure
b. Tripped Circuit Breaker
c. Blown Fuse
d. Electrical Fault
a. Pump Seized
b. Water Control Valve(Dialflo) Setting
c. Electrical fault with pump
d. High voltage in your area
a. Float Valve Leaking
b. Drain from Filtercool Pads
a. Loose Delivery Tube
b. Break in tubing
c. Pump appears to deliver
excessive water to pads
d. Bleed nozzle is blocked
a. Not enough air flow
b. Inadequate Exhaust
a. Dirty Filters
b. Dry Filters
a. Unit located near odor source
b. Algae in water tank
High Mineral Content
ANY FURTHER PROBLEMS PLEASE CONTACT YOUR
BONAIRE CUSTOMER CARE LINE ON 1-800-939-2983
REMEDY
a. Wait for power to be turned on.
b. Reset circuit breaker
c. Replace
d. Call Bonaire Care Line
a. Extension cord dropping voltage
b. Maintenance page. See Pump section.
c. Adjust the Water control valve (Dialflo )
See page 13.
d. Call Bonaire Care Line
a. Check adjustment or replace float valve
if necessary
Normal Operation – adjust float level
b.
a. Check and tighten
b. Replace as necessary
c. Check the condition of the filter pad.
Wash if pad shows heavy buildup of
minerals
d. Clean bleed nozzle
a. Increase fan speed
b. Provide more open area to exhaust
stale air by opening windows and doors
in adjacent rooms.
a. Clean
b. Check control set on COOL mode.
Check water delivery system. Adjust if
necessary.
a. Remove source
b. Clean tank and refill with fresh water.
Bleed off should be checked to see if
bleed nozzle is
necessary and clean Filtercool pad.
Increase the bleed rate – see page 13.
More regular maintenance may be
required.
blocked, clear if
Page | 19