Introduction - BONAIRE Durango 4500E Owner's Manual

BONAIRE WINDOW COOLER

Introduction

Introduction
GENERAL INFORMATION
Thank you for purchasing a quality Bonaire Evaporative Cooler. We care about your safety and would ask
you to spend a few minutes reading these simple instructions before installing or operating this product.
Safety!
Read carefully all of these instructions prior to installing and
operating the unit.


Read and Save these Instructions. Do not throw these Instructions away.

Complete the unit assembly before attempting to install, refer to page 8.


Installation of this cooler in any manner not prescribed by these instructions could cause a safety
issue and WILL void any warranty.


Use only with a 110V 60Hz single phase grounded outlet.


Do not operate cooler with Rear Filter Panel removed.


Do not operate cooler with a damaged cord, plug or other component.


Do not run the power cord under carpet or other floor covering.


Do not use the power cord with an adaptor plug that converts the 3 pin plug into a 2 prong
connector.


Do not use the cooler with an improperly grounded outlet.


Do not alter or modify this cooler.


Do not allow children to install, operate or service this cooler.

WARNING: To reduce the risk of fire or electric shock, do not use this product with any solid state
speed control device.

Use only qualified electricians for replacement or servicing of switches, or electrical motors and
components in this cooler.

Unplug the cooler and position the rotary control knob to the OFF position when installing, servicing or
cleaning.

This Window Mounted Cooler is suitable for installation in windows (either Sash hung or sliding) with a
minimum opening width of 560mm (22") and Height of 560mm (22"), please ensure that the directions
for correct mounting are adhered to for the SAFE operation of this Cooler.
Page | 2