Rack Mounting And Dimensions - QSC PL325 User Manual

Rack Mounting and Dimensions

Use four screws and washers to mount the amplifier to the equipment rack rails. To use the amplifier outside a rack, attach the self-adhesive rubber
feet to the bottom.
For portable, mobile, or other applications where the rack assembly may be moved, we strongly recommend supporting the rear of the amplifier. A
rear rack ear kit is available from QSC's Technical Services Group.
Optional rack handles provide finger grips at each end, making lifting and setting into the rack more comfortable.
15.63" (39.7 cm)
AC Mains Current Draw
This table provides typical current draw for each model as a function of load and output power level. Units of measurement are amperes rms.
NOTE! Current draw shown is for 120 VAC line. For 230 VAC models, multiply values shown by 0.5.
•1/8 power (pink noise) represents typical program with occasional clipping. Use this rating for most applications.
•1/3 power (pink noise) represents severe program with heavy clipping.
•Full power (sine) is continuous sine wave driven at 1% clipping.
Model Load
PL325 8 ohms x 2
4 ohms x 2
2 ohms x 2
PL340 8 ohms x 2
4 ohms x 2
2 ohms x 2
PL380 8 ohms x 2
4 ohms x 2
2 ohms x 2
* Burst mode only. Protective limiting will reduce long-term AC current
10
17.30" (44.0 cm)
3.50" (8.9 cm)
Idle 1/8 Power
Current Pink
(Amperes) Noise
1.0 5.2 A
8.5 A
12.6 A
1.0 7.5 A
11.8 A
19.1 A
2.8 8.7 A
13.1 A
19.3 A
1/3 Power
BTU Pink BTU
Noise
792 8.6 A 893
1387 14.3 A 1981
2178 22.0 A 3339
1150 13.3 A 1682
2114 21.1 A 2864
3495 31.6* A 5306*
918 16.0 A 1101
1355 26.2 A 1674
1768 41.6* A 3278*
Full Power
Sine BTU
Wave
17.0 A 1204
28.3 A 2481
45.3 A 4942
25.9 A 2082
43.5* A 4253*
68.6* A 8601*
38.3 A 1853
70* A 3000*
100* A 6000*