Trim & Wainscoting Material - Kolpak Walk-In Installation & Operation Manual

Install any trim provided per the assembly drawing. Reference the assembly drawing
for trim type and location.
All wainscoting material will be cut to size and shown on the assembly drawing.
Wainscoting material is numbered for easy identification.
Installation of wainscoting material is best accomplished before the refrigeration system
has been started, and before any product has been loaded. In the event that
wainscoting must be added at a later date, ensure that the refrigeration system has
been turned off and that the subsurface has been allowed to return to a normal working
temperature. Installing at a low temperature may not allow the adhesive/sealant to cure
adequately.
 Clean and dry subsurface.
 Follow the sequence of labels on the sheets of material in accordance to the
labeling on the assembly drawing.
 Attach corner pieces (if applicable) first, by applying silicone adhesive to the back
side, and then securing to the panel walls using sheet metal screws every 24".
 The remaining sheets can then be secured using sheet metal screws every 24".
Ensure that at least one fastener is used near each corner of each piece of
material.
 All sheets must be as flush as possible to one another.
 Make sure that all sheets make contact with outside finished floor.
 Caulk all exposed edges of sheeting.
 Allow 1-3 hours for the adhesive/sealant to dry prior to resuming use of the walk-
in.
www.kolpak.com
Trim and Wainscoting Material Installation
CAUTION
800-225-9916 21