Plug Buttons & Penetrations - Kolpak Walk-In Installation & Operation Manual

 Remove protective covering from panels, if applied.
 Check that all cam locks are engaged.
 Insert plug buttons into the cam lock wrench access holes and firmly tap in place
using a rubber mallet.
 Plug buttons supplied for walls and ceilings are vinyl, plug buttons supplied for
floors are either stainless steel or high-strength plastic
 Some areas of walk-in panels contain working parts and should not be
penetrated. Do not make a penetration within 2" of cam lock holes or panel
seams.
 Penetrations must be completely sealed (insulation, foam, etc.) to prevent heat
transfer and condensation/ice formation. Electrical penetrations must be sealed
both internally and externally to form an acceptable seal.
 Penetrations is outdoor ceilings is not permitted.
www.kolpak.com
Plug Button Installation
Penetrations
Trim and Wainscoting Material Installation
800-225-9916 20