Ceiling Support - Kolpak Walk-In Installation & Operation Manual

Apply a continuous 3/8" bead of non-drying (butyl) sealant at all partition wall/ceiling
joints. Apply the sealant on both sides of the panel. This sealant application will assist
in maintaining the vapor barrier.
Indoor enclosures with dimensions of more than 14'-8" in both length and width must
have some type of support for the ceiling panels. Suspended ceiling hangers, foamed
in super ceiling channel, exterior self-support steel beams, or interior steel beams with
column supports must be used. Reference details provided on the as built drawing and
the diagram below for suspended ceiling support installation instructions.
These systems must be installed properly in order to provide the necessary support for
the ceiling panels, allowing them to maintain their design load rating. Failure to do so
may result in an unsatisfactory installation, or an unsafe condition.
www.kolpak.com
CAUTION

Ceiling Support

WARNING
800-225-9916 18