Table of Contents
Advertisement
Homelink Programming
HomeLink is an integrated transceiver (a transmitter and receiver) that can be programmed to activate your garage
door opener. HomeLink can be found on over 140 different vehicle models (see your vehicle's owners manual for
detailed information).
If your Motor Vehicle is equipped with HomeLink, please follow the below instructions to program:
1. For first time programming with a garage door opener, press and hold all 3 HomeLink buttons for approximately
one minute, releasing only when the HomeLink indicator light turns off.
programming the additional HomeLink buttons)
2. To ensure HomeLink is in the proper training mode, press and hold each of the buttons individually. When
pressed, the individual HomeLink button should make the indicator light blink rapidly for 2 seconds and then
turn a solid/continuous light.
A second person may make the following steps quicker & easier. As a safety precaution, DO NOT stand on your
vehicle. Use a stepladder or other stable, safe device.
3.
At the garage door opener receiver (motorhead unit) in the garage, locate the training button (usually near
where the hanging antenna wire is attached to the unit). If there is difficulty locating the training button, please
reference the garage door opener's manual, visit their website www .homelink.com or call at 1-800-355-3515.
4. Press and release the training button (which activates the "training" light) NOT E: Once the button is pressed,
there are 30 seconds in which to initiate the next step.
5. Return to the vehicle and firmly press and hold the desired HomeLink button to be programmed for two
seconds and release. Repeat the "press/hold/release" a second time to activate the door. (You may need to
repeat this sequence up to 3 times to complete the training process).
HomeLink should now activate your rolling code equipped opener.
Once programmed, the HomeLink Wireless Control System or the original hand held transmitter may be used to
activate this garage door opener . In the event there are still programming difficulties, please contact HomeLink at
1-800-355-3515 or visit their website at www.homelink.com.
It is recommended that upon sale of the vehicle, the programmed HomeLink Wireless Control System buttons be
erased for security purposes.
HomeLink buttons until the indicator light begins to flash after about 20 seconds.
37
To erase the programmed HomeLink buttons, press and hold the two outer
(Do not perform this step when
1/2 HP Chain Drive Garage Door Opener
Advertisement
Table of Contents
