B) Install The Door Bell - Home Master GDR02 Operator's Manual

B) Install the Door Be ll
1. Position the control console near the inside door into the garage. Approximately five feet above the
floor to keep out of the reach of small children.
2. Pull the insulation off the ends of the bell wire, then attach the two ends to the back side of the
console as shown.
T his view is of the back
of the control console
3. Attach the door bell to the wall with two screws (M4 -20).
NOT E: Do not over-tighten the screw or you could damage the console.
20
Bell Wire
White (bell wire)
Red (bell wire)
1/2 HP Chain Drive Garage Door Opener