Programming The Remote Controls - Home Master GDR02 Operator's Manual

Programming the Remote Controls

Your garage door opener has already been programmed at the factory to operate with your hand-held remote control.
The door will open and close when you press the first push button.
Below are instructions for programming your opener to operate with additional remote controls.
Programming Remote Control
Using the "Learn" Button on the Garage Door Opener
1. Press and release the "learn" button on the motor unit. T he learn indicator light and warning light w ill glow
steadily for 30 seconds.
Learn
Button
2. Within 30 seconds, press all three push buttons on the remote control then release the buttons. Note:
learn indicator light will flash slowly.
3. Within 30 seconds, press and hold the button on the handheld remote that you wish to oper ate your
garage door for 3 seconds and release. Note: Learn indicator light will blink rapidly and stop.
Erasing All Codes From Garage Door Ope ne r M emory
To deactivate any unwanted remotes, first erase all codes. Push the Learn button and hold for approximately 6 seconds.
All previous codes are now erased.
Reprogram each remote or Keyless entry you wish to use.
Adding or Changing a Ke yless Entry Code
The keyless entry control panel and garage door opener must be programmed with a code in order to operate your
garage door opener with the keyless entry.
33
Learn Button Indicator Light
1/2 HP Chain Drive Garage Door Opener