LAVAZZA Jolie & Milk Operating Instructions Manual page 28

Problem encountered
.
Red flashing light
Milk leaking from the milk
frother.
The milk has not been
heated, it remained cold.
Too hot or burnt milk.
The milk frother is noisy.
Cold beverage preparation
failed.
TROUBLESHOOTING
Possible causes
» Appliance overheated.
» Electrical circuit failure.
» Excessive milk amount.
» Multifunction button pressed
incorrectly.
» Milk frother damaged.
» Incorrect quantity of milk.
» Milk frother damaged.
» Components installed
incorrectly.
» Presence of foreign bodies.
» Multifunction button operated
incorrectly.
» Milk frother damaged.
Solution
» Wait a few minutes and try again.
» Make sure the milk you are using has not been heated
yet.
» Empty milk from container, rinse under cold water
and repeat the cycle.
» Contact Lavazza's Customer Service.
» Observe the levels indicated for the type of
preparation.
» Make sure you have not used an amount of milk below
the MIN level.
» Contact Lavazza's Customer Service.
» Make sure you have not used an amount of milk below
the MIN level.
» Contact Lavazza's Customer Service.
» Make sure to have inserted the whisk correctly.
» Make sure that the lid is properly fitted into place.
» Make sure the appliance is positioned on a stable
surface.
» Make sure no foreign body is present inside the milk
frother.
» Make sure there are no foreign bodies between
the base and the milk frother that prevent proper
operation.
» Make sure to press and holed pressed the
multifunction button for 3 seconds.
» Contact Lavazza's Customer Service.
57
E N