Table of Contents
Advertisement
Microphone Assembly
Wire, amber 12 mm
p/n 115129712
Wire, red 12 mm
p/n 15129612
Use service tool (heat zink) when soldering the microphone wires.
Brush EGC-1700 coating to the solder points and let dry for 15 sec
- then brush once more.
Wire, green 12 mm
p/n 15129812
-
+
IN
Make sure that the suspensions fit well to the
sound studs/ports on the microphones.
Make sure that wire insulation is undamaged.
Note: Make sure that the microphone is
turned right. The wires must be turned
towards the back mic suspension as
shown on the drawing.
Doc. No. 0127420 rev. B
Front mic suspension
Back mic suspension
Page 9 of 15
Advertisement
Table of Contents
