Table of Contents
Advertisement
Childlock
(E 3 sec.)
You can lock the washing machine to
prevent the functions you have set from
being changed inadvertently. To do this,
activate the childproof lock when the
program has started.
To activate/deactivate, press and hold
the Spin speed and Ready in buttons at
the same time for approx. three
seconds.The E symbol appears in the
display panel.
E lights up: The childproof lock is
■
active.
E flashes: The childproof lock is
■
active and the program selector has
been adjusted.To deactivate the
childproof lock, reset the program
selector to the initial program. The
symbol lights up again.
To avoid the program to
Note:
terminate, do not turn the program
selector beyond the Off position.
The childproof lock remains
Note:
active after the program has ended and
the appliance is switched off. You must
always deactivate the childproof lock if
you want to start a new program.
Adding laundry
Following the start of the program, you
can add or remove laundry as required.
Press the Start button to do this.
The Start button indicator lamp flashes
and the machine checks whether it is
possible to add laundry.
If the following appears in the display
panel:
the Õ symbol disappears, and
■
adding is possible.
the Õ symbol lights up, it is not
■
possible to add laundry.
Operating the appliance
To continue the program, press the
button Start.The program continues
automatically.
Notes
Do not leave the door open for too
■
long when adding laundry as water
from the laundry may leak out.
For safety reasons, the door remains
■
locked when the water level or
temperature is high, or while the
drum is turning, and it is not possible
to add laundry during this time.
The load display is not active during
■
reloading.
Changing the programme
Press the Start button.
1.
Select another program.
2.
Press the Start button.The new
3.
program starts from the beginning.
Cancel the programme
For programs at high temperature:
Press the Start button.
1.
To cool down laundry: Select Rinse.
2.
Press the Start button.
3.
For programs at low temperature:
Press the Start button.
1.
Select Spin.
2.
Press the Start button.
3.
Programme end during rinse
hold
- - - appears in the display panel and
the indicator lamp of the Start button
flashes.
Continue the program by:
Pressing the Start button or
■
Selecting a spin speed or setting the
■
program selector to Spin and then
pressing the Start button.
en
29
Advertisement
Table of Contents
