Faults And What To Do About Them - Bosch WAK Series Instruction Manual And Installation Instructions

Faults and what to do about them.

en
Symbol
E:18
E:23
H:32 is flashing alter-
nately with End at the
end of the programme
Other indicators/sym-
bols
Faults and what to do about them.
Faults
Water is leaking from the
machine.
The appliance is not filling
with water.
Detergent is not being dis-
pensed.
The door will not open.
The program will not
start.
The drum briefly jerks or
judders after the program
has started.
The washing water is not
being pumped away.
Water is not visible in the
drum.
36
Cause/remedy
The drain pump is blocked. Clean the drain pump.
■
The drain hose/drain pipe is blocked. Clean the drain hose at the siphon.
■
~ Page 34
There is water in the base trough; the appliance is leaking. Turn off the tap. Call
customer services.
Not a fault – the unbalanced load detection system has interrupted the spin cycle
because the laundry is unevenly distributed.
Distribute small and large items of laundry evenly in the drum. Run the spin cycle
again, if necessary.
Switch off the appliance, wait for five seconds and then switch it on again. If the
indicator/symbol appears again, call our customer services. ~ Page 38
Cause/remedy
Attach the drain hose correctly or replace it.
■
Tighten the threaded joint on the supply hose.
■
Have you pressed the Start button?
■
Is the tap turned on?
■
Could the filter be clogged?Clean the filter. ~ Page 34
■
Is the supply hose kinked or trapped?
■
The safety function is active. Do you want to stop the program?
■
~ Page 29
Is the childproof lock E activated? If so, deactivate it. ~ Page 29
■
Is - - - selected (Rinse Stop = no final spin)? ~ Page 29
■
Can the door only be opened by the emergency release? ~ Page 34
■
Have you pressed the Start button?
■
Is Ready in selected?
■
Is the door closed?
■
Is the childproof lock E activated? If so, deactivate it. ~ Page 29
■
Not a fault – the internal motor test may cause the drum to jerk or judder briefly
when the wash program starts.
Is - - - selected (Rinse Stop = no final spin)? ~ Page 29
■
Clean the drain pump.
■
Clean the drain pipe and/or the drain hose.
■
Not a fault – the water is below the visible area.