The Drain Hose At The Siphon Is Blocked; Filter In The Water Supply Blocked; Faults And What To Do About Them; Emergency Release - Bosch WAK Series Instruction Manual And Installation Instructions

Faults and what to do about them.

en
The drain hose at the siphon
is blocked
Switch off the appliance. Disconnect
1.
the mains plug.
Loosen the hose clamp. Carefully
2.
remove the drain hose, residual
water may leak out.
Clean the drainage hose and siphon
3.
connecting piece.
Reattach the drainage hose and
4.
secure the connection using the
hose clamp.
Filter in the water supply
blocked
First, reduce the water pressure in the
supply hose:
Turn off the tap.
1.
Select any program (except Rinse//
2.
Spin/Empty).
Press the Start button.Allow the
3.
program to run for approximately 40
seconds.
Turn the program selector to Off.
4.
Pull out the mains plug.
Clean the filter on the tap:
5.
Disconnect the hose from the tap.
Clean the filter with a small brush.
34
For standard and Aqua-Secure
6.
models, clean the filter on the rear of
the appliance:
Remove the hose from the rear of
the appliance.
Use pliers to remove the filter and
then clean it.
Connect the hose and check for
7.
leaks.
3
Faults and what to do
about them.
E mergency release
F a u l t s a n d w h a t t o d o a b o u t t h e m .
e.g. in the event of a power cut
The programme will continue running
when the power supply has been
restored.
However, if the laundry has to be
removed, the washing machine door
can be opened as follows:
:
Warning
Risk of scalding!
When you are washing at high
temperatures, there is a risk of scalding
if you come into contact with detergent
solution and laundry.
If possible, leave it to cool down.
:
Warning
Risk of injury!
You may injure your hands if you reach
into the drum while it is turning.
Do not reach into the drum when it is
turning.