Shark SV800 N 54 Owner's Manual page 9

3 Make sure you are working
in a well-lit area and turn the
motorized brush over so you can
see the rotating brush clearly.
4 Inspect the rotating brush for
a build-up of debris. Remove
anything wound around the
brush by carefully cutting it
with scissors. The brush roll is
equipped with a groove to make
inserting scissors easier. Avoid
damaging or cutting the bristles
(fig. 16).
For any other servicing, call Customer Support at 1-800-798-7398 or visit www.sharkclean.com
SV800 N54_E_IB_100823.indd 9
fig. 15
5 Use a flashlight to inspect the
neck of the motorized brush and
inside the air duct at the bottom
of the main body and remove any
debris or blockages.
6 Reattach the motorized brush,
ensuring that it clicks into place
(fig. 17).
fig. 16
fig. 17
RESTARTING AFTER A JAM
If your motorized brush becomes
jammed, it will cease to operate.
1 Turn the unit off and allow it to
cool down for two minutes.
2 Ensure that nothing is blocking
the motorized brush or wrapped
around the brush bar.
3 Turn the power on and the unit
should operate normally.
www.sharkclean.com 9
10-09-01 11:37 AM