Advertisement
Insert bolt guide (97) with carriage bolt M8x50 (112) into the rip fence carrier extrusion's t-slot.
Place rip fence carrier (95) onto carriage bolt (112) and tighten with washer A 8.4 (109) and lock lever M8 (25).
Bolt rip fence extrusion (94) to rip fence carrier (95) with 2 each carriage bolt M6x35 (113), washer A 6.4 (35) and knurled
nut M6 (104).
j
Attach crank handle (75) to crank (51), using cap screw M6.55 (107) and two hex. flat nuts M6 (76).
After assembly the table has to be aligned in order to have the blade running through the centre of the table insert's slot.
To move table sideways, loosen bolts on the lower table trunnion (91). Move table trunnion to left or right, until blade
runs through center of slot. Tighten bolts, be careful that table stays in position while bolts are being tightened.
To set the table square to the blade, the cap nut on the stop on the underside of the table has to be turned in or out,
as required.
.
After the table is correctly aligned affix the scale (96) to the rip fence carrier extrusion (93).
To ensure sufficiennt upright stability machine should be bolted to be bench or table, or mounted on the ELEKTRA
Workstand BAS 315, available as optional accessory.
-
Advertisement
