Bosch Indego 350 Original Instructions Manual page 30

OBJ_BUCH-3008-002.book Page 30 Friday, December 2, 2016 12:09 PM
30 | English
Problem Possible Cause
Areas left uncut Mower requires more cuts to finish the garden
/ too many objects in close proximity
Time slot not long enough for garden size
Distance between wire is too small
Rough lawn conditions
Grass too long
Slopes in garden are too steep
Mower cutting in wet grass conditions
Too many objects inside the garden
Metal construction underneath or next to the
lawn area
Machine gets stuck in Mower cutting in wet grass conditions
garden
Objects/obstacles not marked out
Machine unintention- Objects/obstacles below 5 cm not marked out Mark obstacle using perimeter wire leaving 30cm from
ally cuts flowers etc.
in garden or runs over
certain obstacles
Machine does not Logical cut system depends on the garden
appear to cut logically conditions (e.g. mower may go to the closest
unmown area rather than to the last mowed
spot)
Mower does not always go in a straight line
when traveling between areas
Wire crossed when marking an object
Perimeter wire keeps Wire is not taut between pegs
being cut Distance between pegs is more than 75cm
Machine leaves rag- Height of cut too low
ged finish/poor quali-
Mower requires more cuts to finish the garden Allow mower to run for 3 full cuts to cover whole lawn ar-
ty of cut
Cutting blades blunt
Possible clogging
No charging proce- Charging pins corroded
dure possible
Perimeter wire not Wire terminal has become corroded
detected
F 016 L81 221 | (2.12.16)
Corrective Action
Allow mower to run for 3 full cuts to cover whole lawn ar-
ea
Increase mowing time slot or use Bosch auto calendar
function
Increase distance between the wires around separate
marked objects to at least 75cm
Leave at least 75cm between wire around marked object
and wire at the edge of the lawn
Select uneven ground from Lawn condition within the
menu.
Flatten garden/remove bumps/mark out areas with pe-
rimeter wire – follow installation instructions
Mow garden to at least 40mm before using Indego.
Increase height of cut
Ensure mower only operates on slopes of 15 degrees or
less and full garden is not on a slope.
Do not set the mower to cut in bad weather conditions
Remove objects/obstacles from inside the garden or de-
limit them with perimeter wire
Follow instructions in installation guide for objects
Do not set the mower to cut in bad weather conditions
Remove objects/obstacles from inside the garden or de-
limit them with perimeter wire
object or remove objects/obstacles
Further information available in installation guide
When area is not mowed or mower repeats action often:
remap garden
No corrective action needed
Check wire is laid around object in a clockwise direction
Check installation
Make wire taut and ensure distance between pegs is
maximum 75cm.
Use the wire connectors to repair the break. Avoid using
a verticutter, scarifier, etc. over the perimeter wire
Increase height of cut
ea
Reverse or replace blades (recommended every new
season)
Always turn isolator switch off first, then check under-
neath the mower and clear out as necessary (always
wear protective gloves)
Clean the charging pins
Re-strip the wire for a proper connection
Bosch Power Tools