Page 1
RHT2660DAG PETROL HEDGE TRIMMER OPERATOR’S MANUAL IMPORTAnT! It is essential that you read the instructions in this manual before operating this machine. Keep for future reference.
EnGLISH (Original Instructions) GEnERAL SAFETY RULES DO nOT OPERATE THE EQUIPMEnT WHILE BARE- FOOT OR WHEn WEARInG SAnDALS OR SIMILAR LIGHTWEIGHT FOOTWEAR. Wear protective footwear WARnInG that will protect your feet and improve your footing on THIS HEDGE TRIMMER CAN CAUSE SERIOUS slippery surfaces.
RUnnInG. before transporting in a vehicle. KEEP COOLInG AIR InTAKE (recoil starter area) WHEn SERVICInG USE OnLY IDEnTICAL RYOBI and muffler side of the engine at least 1m away from REPLACEMEnT PARTS. Use of any other parts may buildings, obstructions, and other flammable objects.
Page 4
EnGLISH (Original Instructions) As equipment user, you are responsible for third parties inside the tool. Before use, give the machine time to in the working area. adjust to the temperature of work area. While operating the tool, always hold it firmly with both ...
Page 5
AUTHORISED SERVICE CEnTER for repair. When servicing, do not understand the warnings and instructions in the use only identical replacement parts. operator’s manual, do not use this product. Call Ryobi customer service for assistance. WARnInG: The operation of any power tool can result in foreign objects being thrown into your eyes, which can result in severe eye damage.
EnGLISH (Original Instructions) FEATURES PRODUCT SPECIFICATIOnS -Front Handle....=5.18 m/s =15.18 m/s Engine Displacement ..........26 cc = 13.77 m/s K=1.5 m/s hv, eq Max Engine Performance (in Accordance with ISO 8893) .. -Rear Handle ....=4.16 m/s =15.16 m/s ................0.67 kW =13.69 m/s K=1.5 m/s...
If any parts are damaged or missing, please call RYOBI WARnInG: CUSTOMER SERVICE 1300 361 505 for assistance. To prevent accidental starting that could cause serious...
EnGLISH (Original Instructions) OPERATIOn FILLInG THE TAnK WARnInG: Petrol is extremely flammable and explosive. A fire or explosion from petrol will burn you and others. Always shut off engine before fuelling. Never add fuel to a machine with a running or hot engine. Move at least 10m from refuelling site before starting engine.
EnGLISH (Original Instructions) OPERATIOn that could come in contact with the blades. PRIME - Press the primer bulb 10 times. RotAtinG hAndlE knob SET the choke lever to the COLD START position. Hold the front handle firmly with your left hand and put your right foot onto the base of the rear handle.
Do not use if any damage is carried out by an Authorised Service Center. For your detected. nearest service center call RYOBI CUSTOMER SERVICE 1300 361 505 or visit our website www.ryobi.com.au or WARnInG: www.ryobi.co.nz When servicing, use only identical replacement parts.
EnGLISH (Original Instructions) MAInTEnAnCE REPLACInG BLADES See Figure 7. Periodically inspect the blades for damage and wear. Always use the manufacturer’s specified replacement blades. GEAR BOX COVER Stop the engine and disconnect the spark plug wire. BLADE SCREWS Place the hedge trimmer upside down on a workbench SCREWS and remove the gear box cover screws.
EnGLISH (Original Instructions) MAInTEnAnCE FUEL CAP filtER scREEn AiR filtER WARnInG: lAtch covER A leaking fuel cap is a fire hazard and must be replaced immediately. The fuel cap contains a non-serviceable filter and a check valve. A clogged fuel filter will cause poor engine performance.
EnGLISH (Original Instructions) MAInTEnAnCE SPARK ARRESTOR The spark arrestor must be cleaned or replaced every 50 hours or yearly to ensure proper performance of the product. Spark arrestors may be in different locations depending on the model purchased. Please contact the nearest service dealer for the location of the spark arrestor for your model.
EnGLISH (Original Instructions) TROUBLESHOOTInG PROBLEM POSSIBLE CAUSE REMEDY Clean or replace spark plug. Reset spark plug gap. Refer No spark. to Spark Plug Replacement earlier in this manual. Push primer bulb until bulb is full of fuel. If bulb does not fill, primary fuel delivery system is blocked.
Page 15
Subject to the guarantee condition below, this Ryobi guarantee does not cover damage, malfunction or tool (hereinafter called “the product”) is guaranteed by failure resulting from misuse, neglect, abuse, or used TECHTRONIC INDUSTRIES AUSTRALIA for a purpose for which it was not designed or is not LIMITED (hereinafter called “the Company”) to be free...
Need help?
Do you have a question about the RHT2660DAG and is the answer not in the manual?
Questions and answers