Step 8: Backguard Installation (Optional) - Thermador PRO GRAND PRD606RCG Installation Instructions Manual

STEP 8: Backguard
Installation (optional)
WARNING
Fingers or hands could get pinched when installing the
backguard. Severe injury could result. Use extreme
caution and wear thick protective gloves to avoid potential
laceration to finger or hand while sliding the backguard
down onto the range.
WARNING
To reduce the risk of fire or injury to persons, ensure all
packaging has been removed from accessory devices
before use.
Installation methods will vary upon need. Before you begin
read these instructions carefully. Observe all local codes
and ordinances.
Low Backguard Installation (PA60RLBG)
Tools Needed
T-20 Torx head screwdriver or drill
Protective Work Gloves
1. Remove the T-20 Torx stainless screws in the front
face of the included Zero Inch Clearance Trim
(Figure 15).
Figure 15: Flush Island Trim Front Face Screw Removal
Installation Instructions
2. Remove the drill point screws securing the piece to the
back panel. Lift up to fully remove (Figure 16).
Figure 16: Flush Island Trim Rear Screw Removal
3. Align the back panel of the new accessory with the
flanges on the range side panels right and left rear
corners (Figure 17). Make sure the backguard's front
face is outside the flange on the front side of the range.
4. Reinstall screws removed in Steps 1 and 2.
Figure 17: Backguard Installation
English | 19 |