Step 5: Installing Anti-Tip Device - Thermador PRO GRAND PRD606RCG Installation Instructions Manual

4. If door or handle appears slightly tilted, you may adjust
the hinge receiver by rotating the large Torx-head
screw located directly above the hinge receiver with a
T-30 Torx driver. Rotate each screw respective to its
side and direction the door needs to be adjusted (see
Figure 6).
Figure 6: Hinge Receiver Adjustment Screw
NOTE: The steam oven door is not adjustable.
Adjustment for the Warming Drawer Front
(not all models)
1. To align the warming drawer to the steam oven door,
loosen the (2) Torx screws on both sides of the drawer
frame to adjust the tilt. Tighten the screws.
2. To align the gap between the doors, loosen the (4)
Torx screws on the back side of the warming drawer
door. Adjust the vertical and horizontal direction until
the oven door edges are aligned. Tighten the screws.
2
Figure 7: Warming Drawer Adjustment
Installation Instructions
1 1
STEP 5: Installing the Anti-Tip
Device
For all ranges, an anti-tip device must be installed as per
these instructions.
WARNING
RANGE TIPPING HAZARD:
— All ranges can tip and injury can result. To
prevent accidental tipping of the range,
attach it to the floor by installing the Anti-
Tip Device supplied.
— A risk of tip-over may exist if the appliance
is not installed in accordance with these
instructions. For all ranges an anti-tip
device must be installed.
— A child or adult can tip the range and be
killed.
— DO NOT operate the range without the
anti-tip device in place and engaged.
Failure to do so can result in death or
serious burns to children or adults.
If the range is pulled away from the wall for cleaning,
service or for any other reason, ensure that the Anti-Tip
Device is properly re-engaged when the range is pushed
back against the wall. In the event of abnormal usage
(such as a person standing, sitting, or leaning on an open
door), failure to take this precaution can result in tipping of
the range. Personal injury might result from spilled hot
liquids or from the range itself.
WARNING
ELECTRICAL SHOCK HAZARD:
• Use extreme caution when drilling holes into the wall
or floor as there may be concealed electrical wires.
• Identify the electrical circuits that could be affected by
the installation of the Anti-Tip Device, then turn off
power to these circuits.
• Failure to follow these instructions may result in
electrical shock or other personal injury.
English | 13 |