Suzuki MDG-100 Assembly Manual

Suzuki MDG-100 Assembly Manual

Micro digital grand piano

Advertisement

MDG-100
STOP!
DO NOT ASSEMBLE YOUR PIANO
BEFORE READING THIS GUIDE!
IF YOU HAVE ANY QUESTIONS OR PROBLEMS,
DO NOT CALL OR RETURN PRODUCT TO THE STORE
Micro Digital Grand Piano
Visit www.suzukipianos.com
CALL THIS TOLL FREE HELP LINE
1
8OO
The Name You Know
Easy
Assembly
Guide
854
1594

Advertisement

Table of Contents
loading

Summary of Contents for Suzuki MDG-100

  • Page 1: Assembly Guide

    Micro Digital Grand Piano MDG-100 Easy Assembly Guide STOP! DO NOT ASSEMBLE YOUR PIANO BEFORE READING THIS GUIDE! IF YOU HAVE ANY QUESTIONS OR PROBLEMS, DO NOT CALL OR RETURN PRODUCT TO THE STORE Visit www.suzukipianos.com CALL THIS TOLL FREE HELP LINE 1594 •...
  • Page 2 1. U npacking rand iano The diagram below shows how your piano is packaged: Legs Bench Pedal assembly Box for legs, pedal assembly, pedal support rods and bench AC Power cord, polish cream and cloth Piano Master Box...
  • Page 3 2. U npacking iano edaL ssembLY A. Piano Leg and Lyre Carton: Remove the Leg and Pedal Assembly Box (the top box) from the Master Piano Carton. B. Carefully Handle the Piano Parts • Carefully slit the tape and open the box as – shown. •...
  • Page 4 3. r emove iano iano A. Remove the Piano from the Master Carton: Remove the Leg and Pedal Assembly Box from the Master Piano Carton and Place in an upright position. Use two people to lift your new Piano out of the carton and place on a soft surface such as carpet or a blanket.
  • Page 5 5. a TTaching iano IMPORTANT! One person must hold the piano as indicated, while the other person attaches the legs and pedal assembly. Assembly Positions: Install the Top Leg: Install the Leg at the top of the piano: You will see the following areas on the bottom of your piano: •...
  • Page 6 5. a TTaching iano conTinUed Tighten the Bolts: Install the Back Leg: Install the back piano leg in Tighten both bolts using the provided tool. position. Use the same procedure as the first leg installation. • So far you have attached 2 of the 3 legs.
  • Page 7 7. p edaL ssembLY TTachmenT conTinUed Pedal Assembly Preparation: • Locate the 2 support rods • The ends of these rods have 2 different angles. One angle is very gentle, the other is more sharp. • Using the gentle angle, attach the 2 supporting rods using the brass screws with screwdriver to the back of the pedal assembly as shown.
  • Page 8 9. p osiTioning rand iano WARNING: WARNING: DO NOT PUSH PIANO! When positioning the piano in your home This may cause the legs to break! carry it to the final position. Adjust the Pedal Feet: With your piano placed in its final position, reach Install the Power Cord: under the pedal box and adjust the pedal foot down to firmly contact the floor by turning the...

Table of Contents