Installing The Left Leg; Pedal Assembly Preparation; Pedal Assembly Attachment - Suzuki MDG-100 Assembly Manual

7. p a
edaL ssembLY
8. i T
nsTaLLing he
A.
Use a pillow or make a thick pad by fold-
ing a blanket or quilt in quarters. Place it so the
pedal assembly will land on it. Using 2 or 3 per-
sons, lift the piano and pivot onto the pad.
a (
TTachmenT conTinUed
Tapped Screws
Pedal Cable Socket
L L
eFT eg
)
B.

Pedal Assembly Preparation:

• Locate the 2 support rods
• The ends of these rods have 2 different angles. One angle
is very gentle, the other is more sharp.
• Using the gentle angle, attach the 2 supporting rods using
the brass screws with screwdriver to the back of the pedal
assembly as shown. Tighten but do not over tighten, just
tighten securely.
C.

Pedal Assembly Attachment:

The pedal assembly attaches to the threaded lugs as shown
above. Thread the bolts with washers into the lugs and
tighten.
When you have finished tightening the pedal assembly,
there may be a space between the 3 pedal rods and the top
of their 3 square position holes. This is normal. They do not
fit tightly against the piano bottom.
D.
Attach the pedal support rods to the piano bottom with
the remaining 4 brass screws. Find the pre-drilled holes on
bottom of the piano as shown in the diagram above.
E.
Attach the pedal cable to the pedal cable socket on the
bottom of the piano. See diagram above for location of
pedal cable socket. When plugging in this cable please do
not force it as it will insert correctly when the holes are lined
up properly.
B.
With one person holding the piano in
position,go under the piano and install the final
leg as shown, Finally, using two people, lift the
piano and remove the thick pad.