Mechanism Disassembly - Zenith XBV243 series Service Manual

MECHANISM DISASSEMBLY

HOLDER CLAMP (FIG. 4-1)
1) Release 1 Screws (S1).
2) Unhook 2 Locking Tabs (L1).
3) Lift up the Holder Clamp and separate it from the
Base Main.
CLAMP ASSEMBLY DISC
1) Place the Clamp Assembly Disc as in Fig. (A)
2) Lift up the Clamp Assembly Disc in the direction of
the arrow (A).
3) Separate the Clamp Assembly Disc from the Holder
Clamp.
PLATE CLAMP
1) Turn the Plate Clamp counterclockwise and then
lift.
MAGNET CLAMP / CLAMP UPPER
Fig. 4- 1
VR168 - 923-03485
MECHANISM - DVD
TRAY DISC (FIG. 4-2)
1) Insert and push a Driver in the emergency eject hole
(A) at the right side, or put the Driver on the Lever
(B) of the Gear Emergency and pull the Lever (B) in
direction of arrow so that the Tray Disc is ejected
about 15~20mm.
2) Pull the Tray Disc until it is separated from the Base
Main completely.
4-29
Fig. 4-2
D35E COMBO - SERVICING