Deck Mechanism Disassembly; Drum Assembly - Zenith XBV323 Series Service Manual

DECK MECHANISM DISASSEMBLY

1. Drum Assembly (Fig. A-1-1)
1) Unplug the FPC Drum Connector.
2) Remove three Screws (S1) on the bottom side and sep-
arate the Drum assembly.
3) Unhook (H1), (H2) and separate the FPC Holder and
FPC Cap. (See Fig. B-1)
1-1. Drum Motor
1) Remove two Screws (S2) and disassemble the Stator of
the Drum Motor.
(2) Remove two Screws (S3) and separate the Rotor of the
Drum Motor from the Drum Sub assembly.
NOTE
When reassembling, check to ascertain that the Carbon
Brush is in position.
(S2)
(S2)
(S3)
(A)
Carbon Brush
Stator
(S3)
Drum Motor
Rotor
Drum Sub Assembly
(Fig. A-1-1)
FPC Drum
(S1)
(S1)
H2
Fig. A-1
(Fig. B-1)
FPC Holder
4-2
(S1)
H1
FPC Holder
FPC Cap
FPC Drum
Figure in the opposite direction