Zenith XBV243 series Service Manual page 38

DRUM ASSEMBLY
1) Unplug the Drum FPC Connector.
2) Remove three Screws (S1) on the bottom side and
separate the Drum assembly.
3) Unhook (H1), (H2) and separate the Holder FPC and
Cap FPC. Also see figure (B1).
DRUM MOTOR
1) Remove two Screws (S2) and disassemble the Sta-
tor of the Drum Motor.
2) Remove two Screws (S3) and separate the Rotor of
the Drum Motor from the Drum Sub assembly.
NOTE: When reassembling, check to ascertain that Carbon
Brush is in position.
VR168 - 923-03485
MECHANISM - VCR
(S2)
(S2)
(S3)
(A)
Carbon Brush
Fig. B-1
Holder FPC
Stator
(S3)
Drum Motor
Rotor
Drum Sub Assembly
Drum FPC
(S1)
(S1)
H2
Fig. A-1
4-2
Cap FPC
Drum FPC
Reversed Direction
(S1)
H1
Holder FPC
D35E COMBO - SERVICING