Zenith XBV243 series Service Manual page 40

HOLDER ASSEMBLY CST (FIG. A-2-2)
1) Move the Holder assembly CST in direction of arrow
and lift the left side through slot (D) .
2) Pull the right side of the Holder assembly CST from
the guided holes in the Chassis.
Holder assembly CST
GUIDE CST (FIG.A-2-3)
BRACKET ASSEMBLY L/D MOTOR(FIG. A-2-4)
1) Unplug the Connector (C1).
2) Unhook three Hooks (H3,H4,H5) on the bottom of
the Chassis, lift up the Bracket assembly L/M and
disassemble the Bracket assembly L/D Motor.
(H4)
(H3)
(H5)
GEAR ASSEMBLY RACK F/L (FIG. A-2-5)
1) Move the Gear Assembly Rack F/L in the direction of
the arrow (A) and unhook Hook (H6), pulling back
in front.
2) Separate the Rear Rack F/L in the direction of the
arrow (B).
NOTE: When reassembling, align the Gear part of the Gear
Assembly Rack F/L with the Gear Drive as shown
in the following figure.
VR168 - 923-03485
MECHANISM - VCR
Chassis
(D)
Bracket assembly L/M
ARM ASSEMBLY F/L (FIG. A-2-6)
1) Rotate the Arm assembly F/L in the direction of the
arrow and remove the left side first.
2) Pull the Arm assembly F/L from the guided holes in
the Chassis.
LEVER ASSEMBLY S/W (FIG. A-2-7)
1) Hook the Spring Lever S/W on the Hook (H7) first
as shown below.
2) Unhook Hook (H8) in the left side of the Chassis
and remove the Lever assembly S/W.
(H7)
Spring Lever S/W
4-4
Gear Rack F/L
Gear Drive
Chassis
(H8)
D35E COMBO - SERVICING