PYLE Audio PLA-2150 User Manual page 20

Class-D design Low-frequency information for subwoofer only.High efficient power
power supplies Stiffly regulated PWM power supplies. MOSFET switches maintain
rated power over a wide range of battery voltages.
crossover low pass filter Adjustable from 20Hz to 250Hz with a slope of 24dB per octave.This
allows for the adjustment of the upper point of the frequency bandwidth
and the respective subwoofer.
high pass subsonic filter Adjustable from 15Hz to 40Hz with a slope of 24dB per octave.This allows
for the attenuation of frequencies that are mostly inaudible and cause
unnecessary strain on the amplifier.
protection circuitry Protection against thermal, overload and short circuit conditions.
remote dash-mount gain control This amplifier come complete with a compact remote GAIN CONTROLLER
which can be conveniently mounted on or under the dashboard of your
car.
features and specifications
Class-D MONO BLOCK AMPLIFIER PLA-4300D
output power @ 14.4v DC, 50Hz
RMS Power at @ 4 Ohms
RMS Power at @ 2 Ohms
RMS Power at @ 1.3 Ohms
Maximum Power Output
frequency response
input impedance
input sensitivity
power supply voltage
min speaker lmpedance
T.H.D
S/N ration
fuse
dimensions (W x H x L)
mm
inches
PLA-4300D
400W MONO
700W MONO
1200W MONO
4000W MONO
20 Hz-250 Hz (-3dB)
10K Ohms
18
250mV~4V Adjustable
14.4V DC Neg. Ground (10.5-16V)
1 Ohm
0.1%
>90dB
40A x 2
281 x 59 x 381
11.06 x 2.32 x 15