PYLE Audio PLA-2150 User Manual page 14

crossover mode selector when used with normal, full range systems, set this switch to "FULL." If
you wish to use the internal crossover to power a driver of specific frequency
range, use the "LOWPASS" or "HIGHPASS" settings.
input level control use this control to match the outputs of your head unit to the amplifier.
Starting with your head unit set at about the 2 o'clock position, increase
the amp level control until distortion begins to occur, and reduce slightly
from this point.
low pass frequency control when the crossover selector switch is in "low pass" mode, this control
sets the upper frequency limit for audio program sent to the speakers.
high pass frequency control when the crossover selector switch is in "high pass" mode, this control
sets the lower frequency limit for audio program sent to the speakers.
Remote Bass Boost Plug in the Remote Bass Boost Control wire in here.(PLA-2150 without)
bass boost level control this control permits adjustment of the bass level up to an increase of
approximately 18 dB.
low level inputs this amp features gold-plated RCA input jacks for high impedance input.
Use these with car stereo output which uses RCA-type connector cables.
high level inputs if your car stereo lacks RCA-type output jacks, you may connect speaker
output leads to these input connectors.
power LED this indicator is illuminated when power is applied.
protection LED this indicator is illuminated when built-in protection circuitry is activated.
power fuse the fuse protects the amplifier and your car's electrical system from short
circuit conditions.
power terminals use these connectors to deliver power, ground and remote turn-on control
to the amplifier.
speaker connections these terminals are 14K gold plated to guarantee high conductivity and
minimum signal loss.
features and specifications
2 ch amp PLA-2150 • PLA-2250
PLA-2350 • PLA-2450
output power @ 14.4v DC, 1KHz PLA-2150
RMS Power @ 4 Ohms 40 Watts x 2
RMS Power @ 2 Ohms 60 Watts x 2
Maximum Power Output 300 Watts x 2
frequency response
input impedance
low level inputs
high level inputs
input sensitivity
low level inputs
high level inputs
power supply voltage 14.4V DC Neg. Ground (10.5-16V)
matching speaker impedance
stereo mode
bridged mode
maximum current draw 15A
dimensions (W x H x L)
mm
281 x 59 x 209
inches 11.06 x 2.32 x 8.25
PLA-2250 PLA-2350 PLA-2450
75 Watts x 2 75 Watts x 2 100 Watts x 2
125 Watts x 2 125 Watts x 2 175 Watts x 2
500 Watts x 2 600 Watts x 2 700 Watts x 2
15 Hz-30 KHz
10K Ohms
100 Ohms
12
250mV
2.5V
2-4 Ohms
4-8 Ohms
15A 20A 30A
281 x 59 x 280 281 x 59 x 305 281 x 59 x 343
11.06 x 2.32 x 11 11.06 x 2.32 x 12 11.06 x 2.32 x 13.5