rec tec grill RT-700 Owner's Manual page 14

Test Mode - With grill OFF, press and hold the settings button to enter the Adjustable Parameters
menu. Enter Test Mode from either of the two screens AUG or OFS by pressing the power button.
Each additional press of the power button will advance you through the 8 Test Mode screens. The
last screen is the bYE screen. While on the bYE screen, press the Settings button to return to the
adjustable parameters screen then press and hold the Settings button and your grill's controller will
return to the OFF state.
Adjustable Parameter 1: Min Feed Rate - Min Feed Rate is the minimum rate that the auger is
allowed to feed fuel to the fire pot, regardless of Set Point. Decreasing the value will allow the grill
to achieve lower temperatures but will increase the risk of flameouts. Increasing the value will pre-
vent losing fire but will limit your ability to maintain low temperatures on hot, sunny days.
Adjustable parameter 1 controller will display AUG. Additionally, the current auger minimum feed
rate will be displayed as a number. Turning the temperature knob clockwise will increase and turning
counter-clockwise decrease the value within the range of 30 - 250. (Factory preset: 65)
Adjustable Parameter 2: Temperature Offset - Your grill has been precisely calibrated at our facil-
ity, but the Temperature Offset allows you to customize how your controller will operate. Should
you choose to rely on a secondary temperature probe, you can use the following process to recali-
brate your Smart Grill Technology Controller.
Adjustable parameter 2 will display OFS. Additionally, the current temperature offset percentage
value will be displayed. Turning the temperature knob clockwise will increase and turning counter-
clockwise decrease the value within the range of -25.0 to 25.0. (Factory preset: 0)
VEr XXX - displays current software version.
Screen 5-1 is test mode for your auger motor. You should be able to look in your grill's fire pot and
see the end of the auger turning very slowly.
Screen 5-2 is test mode for your grill's ignition system. You should be able to look into grill's fire
pot and see your ignitor begin to glow within a few minutes. DO NOT TOUCH THE IGNITOR.
Screen 5-3 is test mode for your grill's blower fan. You should be able to hear the fan blowing.
Screen 5-4 is test mode for your grill's control knob. You can turn the knob to see the 000 value
increase and decrease as you turn the knob.
Screen 5-5 is test mode for your grill's temperature sensor and Probe A and Probe B. You can see
the temperature values for each displayed on the screen. (A value of - - - means the probe is not
plugged in or the grill's sensor is not connected.)
Screen 5-6 is a internal quality control screen that has no function for the user.
Screen bYE is the final screen of the test mode. Pressing the power button again will return you to
Screen 5-1. Pressing the settings button will return you to the Settings Menu, at which time you can
hold the Settings Button to exit Settings Menu and get you back to a blank screen.
VEr Screen
VEr
5-3
Screen 5-3
Adjustable Parameter 1 Adjustable Parameter 2
1 2
### AUG
65 0
5-4 5-5
FAN NOb
Probe A
000 - - -
Screen 5-4 Screen 5-5
Screen 5-2
Screen 5-1
5-1 5-2
IGN AUG
Actual
5-6 BYE
85ºF UF1
Probe B
- - -
Screen BYE
Screen 5-6
10
IGN
©2018, Rec Tec Industries, LLC