Initial Setup Procedure; Temperature Probes - rec tec grill RT-700 Owner's Manual

Initial Setup Procedure

For your first lighting, follow this Initial Setup Procedure.
Before starting your REC TEC BULL, inspect the burn area inside the grilling area. It is a recom-
mended practice to go through the following procedure at initial start up.
1. Open the main lid and remove the stainless steel cooking grate, drip pan, and flame deflec-
tor. Make sure all packing material has been removed.
2. Open the pellet hopper lid found on the back side of your grill and check for any foreign
objects.
3. Plug your REC TEC BULL into the nearest 110 Volt AC GFCI outlet. (Note: If your home
does not have a GFCI outlet, you should have one installed by an electrician.)
4. Put no more than 1/2 cup of pellets directly into the fire pot to provide fuel to burn while
auger tube self-primes.
5. Pour pellets into your grill's pellet hopper.
6. Wash cooking grate with mild soap and water.
7. Reinstall the stainless steel flame deflector, drip pan, cooking grate, and close lid.
Tip: If you want to line your drip pan with foil for ease of cleanup, we recommend you do this
before your initial burn in. When lining drip pan, keep foil inside drip pan edges and do not
wrap around as this can restrict airflow.
8. Turn on your REC TEC BULL by pressing the power button at the left of the panel. Set
temperature to 400ºF by turning temperature control knob.
9. Within a few minutes you will see smoke, and your grill will light.
10. Once grill achieves 400ºF, allow it to run for 1 hour, this will provide a final cure and remove
any residue that may have accumulated during manufacturing and shipping.
After this initial burn, your grill is ready for cooking.
Plug your temperature probes into the grill's controller probe ports A and B.
Feed probes through the probe port hole on the left side of grill cooking chamber.
Insert probes into thickest portion of meat for most accurate reading.
See page 20 for USDA saftey guidelines.
Unplugging probes and cleaning with damp cloth will prolong the life and accuracy of your probes.
Reinstalling rubber protectors over connection ports on controller after each cook will prolong the life
and quality of your controller.
DO NOT FULLY SUBMERGE PROBES IN WATER OR WASH IN DISHWASHER
Call our customer service at 1-706-922-0890
10am-8pm EST. Mon-Thurs;
10am-7pm EST Fri;
9am-3pm EST Sat.

Temperature Probes

©2018, Rec Tec Industries, LLC
8