rec tec grill RT-700 Owner's Manual page 10

STEP 6 – Install Pull bar Handle
Attach the pull bar handle (#6) using the two bolts that are screwed into the handle. The Beauty ring
stays attached to the pull bar handle.
STEP 7 – Bull Horn Handle Assembly
Attach bull horn handles (#5) to grill lid using the small bolts that are screwed into handle.
Proper placement will result in the handle facing inward with the tip slightly upward.
STEP 8 – Stand Grill Upright
You will need two people to do this as the grill is very heavy.
STEP 9 – Install the Smoke Stack
Install the Smoke Stack (#7) using provided hardware. (See Bolt Assembly Order diagram.)
STEP 10 - Flame Deflector (#9), Drip Pan (#10) Cooking Grates (#11), and
Drip Bucket (#12) Installation
Open the lid of the REC TEC BULL. Install the Flame Deflector (#9) over the Air Box Assembly
with the small notches in the flame deflector over the small tabs located at the inside front and the
large cutout to the rear of the grill body.
Install Drip Pan (#10) with the short lip sitting on the left-side drip pan support and
the longer lip resting on the right-side lower support. Make sure to leave equal gap between Drip
Pan and front and back chamber walls to ensure even heat distribution.
BE CAREFUL NOT TO DAMAGE THE TEMPERATURE SENSOR WHILE
INSTALLING THE DRIP PAN.
(TIP: many customers line their drip pan with aluminum foil for easier clean up. When lining drip
pan, keep foil inside drip pan edges and do not wrap around as this can restrict airflow.)
Install the Cooking Grates (#11) by resting it flat on the front and back ledges inside chamber. Be
careful to avoid the temperature sensor during placement.
Install the Drip Bucket (#12) by clipping the handle to the integrated hook on grease spout on right
side of grill and allow it to hang.
Questions?
Call our customer service at 1-706-922-0890
10am-8pm EST. Mon-Thurs;
10am-7pm EST Fri;
9am-3pm EST Sat.
Bolt Assembly Order
©2018, Rec Tec Industries, LLC
6