Denial Of Service Setting; Port Forwarding - LG LSP-W1000 Owner's Manual

Save: After completing the settings
on this page, click Save to
save the settings.
Reset: Click Reset to restore to
default values.
Current Blocked
Table:
Note:
If you blocked some port(s), the Netstation may not
activate correctly.

Denial of Service Setting

A DoS (Denial of Service) attack does not attempt to
steal data or damage your PCs, but overloads your
Internet connection so you cannot use it - the service
is therefore unavailable.
If DoS function is enabled, DoS attacks will be detect-
ed and blocked. The default is unabled. It is strongly
recommended that this setting be left enabled.
Enable DoS
Check to enable the DoS preven-
Prevention:
tion function. Select the item listed
to enable.
Enable Source
Set the threshold for the frequency
IP Blocking
of packets that are allowed to
s Block time
pass through. The default value is
(sec)
50 packets per seconds. You can
adjust the value according to your
need. It is recommended that you
set a practical number so that your
network performance won't be
hampered.
Select All Click to selct all listed items.
Clear All Click to clear all listed items.
Apply
Click to save the current settings.
Changes
30

Port Forwarding

Enable Port Check to enable the Port
Forwarding: Forwarding function.
Servers: Select the server.
Local IP Enter the Local IP address.
Address:
Protocol: Select the protocol (TCP, UDP
or Both) used to the remote
system or service.
Public Port: Enter a public port number.
Private Port: Enter a private port number.
Description: You may key in a description
for port range.
Save: After completing the settings
on this page, click Save to
save the settings.
Reset: Click Reset to restore to
default values.
Current Port Shows the current Port
Forwarding Forwarding information.
Table:
Delete Selected: Click to delete selected item.
Delete All: Click to delete all listed items.
Reset: Click Reset to restore to
default values.
Note:
If you change the fort number that is registered auto-
matically from the system, you can not monitor using
the WAN