Sender Mail; Receiver Mail; Notification - LG LSP-W1000 Owner's Manual

Sender Mail

Mail Send
l
- ON: Select to enable Mail function.
- OFF: If you set to OFF, the [SMTP Server], [Mail
Address] and [Password] options are dimmed
and these options are not set.
SMTP Server: Enter the SMTP Server address.
l
Mail Address: Enter the mail address.
l
Password: Enter the password.
l
Notes:
• After change the options, select [Apply] icon and
press ENTER to confirm the settings. When you
press ENTER, the test mail will be sent via the
SMTP server to the user mail address automati-
cally and the settings are saved when the mail
test of the SMTP server is correct.
• You should know the SMTP server address of
a mail service provider to use the SMTP server.
(You should use the port number 25 of the SMTP
server for this function.)

Receiver Mail

Address (1~4): Enter the receiver mail address.
l
You can input up to 4 E-mail addresses.
Note:
After change the options, select [Apply] icon and
press ENTER to confirm the settings.

Notification

Set the notification options.
1. Select item and press ENTER.
A checking mark appears in front of the selected
option.
2. Select [Apply] icon and press ENTER to confirm
your settings.
Motion Detection: Sends an E-mail when motion
l
detection has occurred.
USB storage Full: Sends an E-mail when the disc
l
has fully recorded.
Admin PW Change: Sends an E-mail when the
l
administrator password has changed.
Camera Disconnect: Sends an E-mail when a
l
video signal from the camera has stopped because
of a cable disconnection or malfunction of a cam-
era.
Note:
For the E-mail sending function, the motion detection
has 1 minute term before sending an E-mail again.
21