Advertisement
Step 10
Separate the EXTENSION SLIDES (P) from the EXTENSION RAILS (O)
å
as shown in the upper diagram. Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (O) to the ENDS (A and B). Use four
å
GOLD 5/16" FLAT HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole
å
shown in the enlarged diagram. Then, slide the inner cartridge of the
EXTENSION RAIL in to fi nd the other hole that lines up with the hole in
the END. Turn a SCREW into this hole.
P
Push the release lever in and pull the SLIDE from the RAIL.
Page 14
B
O
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
A
414675
3S
O
O
Open end
www.sauder.com/services
Advertisement
