System Reset Function; Phone Set-Up; Anti-Theft Protection - Alfa Romeo MiTo 2013 Owner's Handbook Manual

SYSTEM RESET function

This function is used to restore all settings to the factory values.
The options are:
❒ NO: no restore intervention;
❒ YES: the default parameters will be restored. During this
operation, the word "Resetting" appears on the display. At the
end of the operation, the source does not change and the
previous situation will be displayed.

PHONE SET-UP

If a hands-free kit is installed on the car, when there is an incoming
phone call the radio audio will be connected to the telephone
output. The telephone audio always arrives at a fixed volume, but it
can be adjusted during a conversation using the ON/OFF
button/knob.
The fixed telephone audio volume can be adjusted using the
"SPEECH VOLUME" function in the Menu (where the function is
provided). The word "PHONE" will appear on the display during
the deactivation of the audio for the phone call.
If there is no "SPEECH VOLUME" function in the Menu, volume
adjustment occurs in the same way as it does with Blue&Me™.

ANTI-THEFT PROTECTION

The radio is equipped with an anti-theft protection system based on
the exchange of information between the radio and the electronic
control unit (Body Computer) on the car.
This system guarantees maximum safety and avoids the entry of
the secret code each time the radio power supply is disconnected.
If the check has a positive outcome, the radio will start to function,
whereas if the comparison codes are not the same or if the
electronic control unit (Body Computer) is replaced, the device will
ask the user to enter the secret code according to the procedure
described in the paragraph below.
Entering the secret code
When the radio is switched on, if the code is requested, the display
will show "Radio code" for about 2 seconds followed by four
dashes "- - - -".
The code is made up of four numbers from 1 to 6, each
corresponding to one of the dashes.
To enter the first digit of the code, press the corresponding button
of the pre-selected stations (from 1 to 6). Enter the other code
numbers in the same way.
If the four digits are not entered within 20 seconds, the display will
show "Enter code - - - -". If this occurs, it is not considered an
incorrect code entry.
After entering the fourth digit (within 20 seconds), the radio will
start to operate.
279