Speed Volume Function; Radio On Volume Function - Alfa Romeo MiTo 2013 Owner's Handbook Manual

SPEED VOLUME function

(speed-based volume change)
(excluding versions with Bose HI-FI system)
This function automatically adapts the volume level to the speed of
the car, increasing the volume when the speed increases to
maintain the ratio with the noise level inside the passenger
compartment.
To activate/deactivate the function, press the
words "Speed volume" appear on the display, followed by the
current status of the function:
❒ Off: function deactivated
❒ Low: function activated (low sensitivity)
❒ High: function activated (high sensitivity).
276

RADIO ON VOLUME function

(radio volume limit activation/deactivation)
This function makes it possible to activate/deactivate the volume
limits when the radio is turned on.
The display shows the function status:
❒ "Radio on vol – Limit on": when the radio is switched on the
volume level will be: – if the volume level is equal to or higher
/ buttons. The
than the maximum value, the radio will switch on at the
maximum volume;
– if the volume level is between the minimum and maximum values,
the radio will switch on at the same volume as before it was
switched off;
❒ "Radio on vol – Limit off": the radio will switch on at the volume
level it was at before switching off. The volume may be between
0 and 40.
To change the setting of the selected function, use the
/ buttons.
NOTES
❒ Using the Menu it is only possible to adjust the
activation/deactivation of the function and not the minimum or
maximum volume value.
❒ If the "TA" or "TEL" functions or an external audio source are
activated when the radio is turned on, the radio will switch on at
the volume set for these sources. When the external audio source
is deactivated, the volume can be adjusted between the
minimum and maximum levels.
❒ If the battery charge is low, it will not be possible to adjust the
volume between the minimum and maximum levels.