Enhanced Accident Response System Reset Procedure - Alfa Romeo Giulia 2017 Owner's Manual

Enhanced Accident Response
System Reset Procedure
After the event occurs, when the
system is active, a message regarding
fuel cutoff is displayed. Turn the ignition
switch from ignition AVV/START or
MAR/ACC/ON/RUN to ignition
STOP/OFF/LOCK. Carefully check the
vehicle for fuel leaks in the engine
compartment and on the ground near
the engine compartment and fuel tank
before resetting the system and starting
the engine.
Depending on the nature of the event
the left and right turn signal lights,
located in the instrument panel, may
both be blinking and will continue to
blink. In order to move your vehicle to
the side of the road, you must follow
the system reset procedure.
Customer Action
Note:
Each step MUST BE held for at least
two seconds
1. Turn ignition
STOP/OFF/LOCK.
(Turn Signal Must be
placed in Neutral
State).
2. Turn ignition
MAR/ACC/ON/RUN.
122
Customer Action
Note:
Each step MUST BE held for at least
two seconds
3. Turn right turn
signal switch ON.
4. Place turn signal
in neutral state.
5. Turn left turn
signal switch ON.
6. Place turn signal
in neutral state.
Customer Will See
7. Turn right turn
signal switch ON.
8. Place turn signal
in neutral state.
9. Turn left turn
signal switch ON.
Right turn light
BLINKS.
Left turn light is OFF.
Customer Will See Customer Action
Note:
Each step MUST BE held for at least
two seconds
Right turn light is ON 10. Turn left turn
SOLID. signal switch OFF.
Left turn light (Turn Signal Switch
BLINKS. Must be placed in
Neutral State).
Right turn light is
OFF. 11. Turn ignition
Left turn light STOP/OFF/LOCK.
BLINKS.
12. Turn ignition
Right turn light MAR/ACC/ON/RUN.
BLINKS. (Entire sequence
Left turn light is ON needs to be
SOLID. completed within
one minute or
Right turn light
sequence will need
BLINKS.
to be repeated).
Left turn light is OFF.
Turn hazard flashers
Right turn light is ON
OFF (Manually).
SOLID.
If a reset procedure step is not
Left turn light
completed within 60 seconds, then the
BLINKS.
turn signal lights will blink and the reset
Right turn light is
procedure must be performed again in
OFF.
order to be successful.
Left turn light
BLINKS.
Right turn light is ON
SOLID.
Left turn light is ON
SOLID.
Customer Will See
Right turn light is
OFF.
Left turn light is OFF.
System is now reset
and the engine may
be started.