Before You Start - Silk'n FaceFX Instructions For Use Manual

Treating with Silk'n FaceFX for the First Time
The skin should be, clean, dry and free of any powder, gel or cream.
If necessary a light oil based serum may be applied thinly to the skin to help glide the device.
Allow serum to absorb into the skin before treating. See "cleaning the Silk'n FaceFX" section.
Connect the ADAPTOR PLUG to the FaceFX
Connect the FaceFX to an electrical outlet
Press the POWER ON/OFF SWITCH. The green READY/TREATMENT INDICATOR LIGHT
(K) will start blinking, and shortly afterwards will be lit steadily.
Your FaceFX is ready for treatment.
Place the TREATMENT SURFACE on your skin. The LED light will automatically activate.
Apply light pressure while slowly moving the FaceFX APPLICATOR in small circular motions.
The TREATMENT SURFACE temperature will slowly increase.
Perform the treatment for 5-7 minutes on each area.
It is recommended to apply a small amount of a moisturizing cream on the treated skin areas
after each session and to massage it gently in circular motions.

Before You Start

Before using Silk'n FaceFX for the first time, please read this manual in its entirety. Pay particular
attention to sections on device use procedures, device operation, and after-use procedures.
What is Silk'n FaceFX?
Silk'n FaceFX is a hand held light emitting diode (LED) device for facial treatments of periorbital
wrinkles, reducing pore size and temporary improvement of the appearance of the skin. The light
emitted by Silk'n FaceFX stimulates deep skin tissue and achieves facial FaceFXvenation. Typical
areas for Silk'n FaceFX treatment are the neck, the cheeks, the forehead, and around the eyes.
3