Web Management Network Setup - Fenger FDM-4000i Installation & Configuration Manual

Web Management Network Setup

DHCP – Use the Scroll Up/Down button to select DHCP. Press the OK button to enter
the DHCP menu. Use the Scroll Up/Down button to Enable/Disable. Press the OK button
to set.
 IP Address – Use the Scroll Up/Down button to select IP Address. Press the OK button
to enter the IP Address menu. Use the Scroll Up/Down button to enter the IP Address.
Use the Scroll Up/Down menu to select the desired IP Address then press the OK button
to set. Repeat the process until the IP Address is completed. Press the OK button to set.
Note: If DHCP is enabled you will not be able to set an IP address. Select DHCP disabled
if Static IP Address required.
Subnet Mask – Use the Scroll Up/Down button to select Subnet Mask. Press the OK
button to enter the Subnet Mask menu. Use the Scroll Up/Down button to enter the
Subnet Mask. Use the Scroll Up/Down menu to select the first number of the desired
Subnet Mask then press the OK button to set. Repeat the process until the Subnet Mask is
completed. Press the OK button to set.
Gateway Address – Use the Scroll Up/Down button to select Gateway Address. Press
the OK button to enter the Gateway Address menu. Use the Scroll Up/Down button to
enter the Gateway Address. Use the Scroll Up/Down menu to select the first number of
the desired Gateway Address then press the OK button to set. Repeat the process until the
Gateway Address is completed. Press the OK button to
Back to Main - Select Back to Main to escape the Web Management Net Setup Menu.
set.
- 23 -
FDM-4000i Manual V1.0