Fenger FDM-4000i Installation & Configuration Manual page 22

Gateway Address. Use the Scroll Up/Down menu to select the first number of the desired
Gateway Address then press the OK button to set. Repeat the process until the Gateway
Address is completed. Press the OK button to set.
Back to IP Streaming Setup- Select Back to Main to escape the Web Management
Network Setup Menu.
Streaming Setup
Select IP Output – Use the Scroll Up/Down button to enter the IP Output selection.
Select IP output port 1 to 4 to set. 
Enable IP Streaming – Use the Scroll Up/Down button to enter Enable IP Streaming
selection. Press OK button to select ENABLE/DISABLE the IP Streaming.
Streaming Method – Use the Scroll Up/Down button to select Streaming Method. Press
the OK button to enter the Streaming Method menu. Use the Scroll Up/Down button to
select the Streaming Method required. Select: RTP UNICAST, UDP UNICAST, RPT
MULTICAST, or UDP MULTICAST. Press the OK button to set.
1 st Destination IP – Use the Scroll Up/Down button to select 1
(Address). Press the OK button to enter the 1
Scroll Up/Down button to set the Destination IP Address. Note: By selecting Unicast in
the Streaming Method Menu the default address begins at 192.168.1.20. Use the Scroll
Up/Down button to set the Destination IP Address. Press the OK button to set. Multicast
begins at 224.1.1.1. Press the OK button to set.
Destination IP Address Range(s):
Unicast: 0.0.0.0 ~ 223.255.255.255
Multicast: 224.0.0.0 ~ 239.255.255.255
st
1 Destination Port Number – Use the Scroll Up/Down button to select DES Port
Number (Destination Port Number). Press the OK button to enter the 1
Number menu. Use the Scroll Up/Down button to set. Press the OK button to set.
For 2 IP Version Only ( 2
nd
2 Destination IP – Use the Scroll Up/Down button to select 2
(Address). Press the OK button to enter the 2
Scroll Up/Down button to set the Destination IP Address. Note: By selecting Unicast in
the Streaming Method Menu the default address begins at 192.168.1.21. Use the Scroll
Up/Down button to set the Destination IP Address. Press the OK button to set. Multicast
begins at 224.1.1.2. Press the OK button to set.
Time To Live – Use the Scroll Up/Down button to select Time To Live menu. Press the
OK button to enter the Time To Live .menu. Use the Scroll Up/Down button to select
TTL. Press the OK button to set. Default Settings: Unicast: 63. Multicast: 4. TTL Range:
1~ 255.
Back to IP Streaming Setup- Select Back to Main to escape the Streaming – IP
Streaming Sub Menu.
nd nd
Destination IP / 2
- 22 -
st
Destination IP Address menu. Use the
Destination Port) Functions
nd
Destination IP Address menu. Use the
FDM-4000i Manual V1.0
st
Destination IP
st
Destination Port
nd
Destination IP