Fenger FDM-4000i Installation & Configuration Manual page 21

LCN-Use the Scroll Up/Down button to set LCN. Press the OK button to enter The
Source ID menu. Use the Scroll Up/Down to set the Source ID. Range: 1 to 999. Press
OK to set.
Aspect Ratio – Use the Scroll Up/Down button to select Aspect Ratio. Press the OK

button to enter the Aspect Ratio menu. Use the Scroll Up/Down button to select the
desired Aspect Ratio option of 4:3 or 16:9 then press the OK button to set. Factory
default: 4:3.
Brightness – Use the Scroll Up/Down button to select Brightness. Press the OK button to
enter the Brightness menu. Use the Scroll Up/Down button to select the desired
Brightness value (0 to 255) and press the OK button to set. Factory default: 128.
Contrast – Use the Scroll Up/Down button to select Contrast. Press the OK button to
enter the Contrast menu. Use the Scroll Up/Down button to select the desired Contrast
value (0 to 255) and press the OK button to set. Factory default: 128.
Saturation – Use the Scroll Up/Down button to select Saturation. Press the OK button to

enter the Saturation menu. Use the Scroll Up/Down button to select the desired Saturation
value (0 to 255) and press the OK button to set. Factory default: 128.
Hue – Use the Scroll Up/Down button to select Hue. Press the OK button to enter the
Hue menu. Use the Scroll Up/Down button to select the desired Hue value (0 to 255) and
press the OK button to set. Factory default: 128.
 Sharpness – Use the Scroll Up/Down button to select Sharpness. Press the OK button to
enter the Sharpness menu. Use the Scroll Up/Down button to select the desired Sharpness
value (0 to 127) and press the OK button to set. Factory default: 64.
Back to Main- Select Back to Main to escape the Encoder Setup Menu.
IP Streaming Setup
Network Setup
DHCP – Use the Scroll Up/Down button to select DHCP. Press the OK button to enter
the DHCP menu. Use the Scroll Up/Down button to Enable/Disable. Press the OK button
to set.
 IP Address – Use the Scroll Up/Down button to select IP Address. Press the OK button
to enter the IP Address menu. Use the Scroll Up/Down button to enter the IP Address.
Use the Scroll Up/Down menu to select the desired IP Address then press the OK button
to set. Repeat the process until the IP Address is completed. Press the OK button to set.
Note: If DHCP is enabled you will not be able to set an IP address. Select DHCP disabled
if Static IP Address required.
Subnet Mask – Use the Scroll Up/Down button to select Subnet Mask. Press the OK
button to enter the Subnet Mask menu. Use the Scroll Up/Down button to enter the
Subnet Mask. Use the Scroll Up/Down menu to select the first number of the desired
Subnet Mask then press the OK button to set. Repeat the process until the Subnet Mask is
completed. Press the OK button to set.
Gateway – Use the Scroll Up/Down button to select Gateway Address. Press the OK
button to enter the Gateway Address menu. Use the Scroll Up/Down button to enter the

- 21 -

FDM-4000i Manual V1.0