Table of Contents
Advertisement
Modulator Configuration via Front Panel LCD
Once the encoder is powered up it will go through its initial booting process. Once the unit has
completed its initial "Booting" up process the LCD will display IN-1..., Bit Rate information,
Channel-1...., and other information in the LCD Display Window. When visible the unit is ready
for programming or operation.
The LCD will display data as it cycles through the available information.
Screen Views:
1: Inputs, Mbps, Channel Names, Video Output Type, Audio Output type
IN-1 6.796Mbps CHANNEL-1
IN-2 6.796Mbps CHANNEL-2
2: Use the Scroll Up/Down button to display RF data, Physical Output Channel, Constellation,
FEC setting, OFDM Mode Selection.
RF-1 E21 (474MHz) QAM 64
RF-2 E22 (482MHz) QAM 64
3: Use the Scroll Up/Down button to display IP address
1st DESTINATION IP
1st DESTINATION PORT 10000
– To access the Main Menu first enter the password by pressing the OK
Main Menu
button. Use the Scroll Up/Down buttons to enter the password. Once the password is
entered press the OK button again and the LCD Screen will display "Common Setup".
Password –
Use the Scroll Up/Down buttons to enter the password. Password is 0000.
Press the OK button for each number to enter the password. Press OK again after the
display shows... SD Series.
PASSWORD=?
0
MPEG2 MP2
MPEG2 MP2
7/8 1/32
8K
7/8 1/32
8K
192.168. 1. 20
- 18 -
FDM-4000i Manual V1.0
Advertisement
Table of Contents
