Avocent AutoView 1000R Installer/User Manual page 44

38
AutoView 1000R/ AutoView 2000R Installer/User Guide
receive a warning indicating that all users (remote and local) will be
disconnected. Click OK to confirm and begin the test.
The Diagnostics dialog box appears. The top section of the dialog box displays
the hardware tests. The bottom portion divides the tested AVRIQ modules into
three categories: online, offline or suspect.
NOTE: An AVRIQ may appear to be offl ine while it is being upgraded.
Next to each item to be tested, you will see a pass (green circle) or fail (red x)
symbol appear to the left of each item as that test finishes. A symbol will also
display to the left of the LAN connection to indicate if it is (green) or is not
(red) accessible and functional. The following table details each of the tests.
Diagnostic Test Details
Test
Memory Tests
Firmware CRCs
Comm Interfaces
Switch Controller test
Local and Remote Video
LAN Connection test
On-line AVRIQs
Offl ine AVRIQs
Suspect AVRIQs
To run diagnostic tests:
1. If OSCAR is not open, press Print Screen. The Main dialog box will appear.
2. Click Commands - Run Diagnostics. A warning message appears
indicating that all users will be disconnected.
3. Click OK to begin diagnostics.
-or-
Click X or press Escape to exit the dialog box without running a
diagnostic test.
4. All users are disconnected and the Diagnostics dialog box displays.
Description
Reports on the condition of the main board RAM
Validates the current fi rmware images stored in the system's FLASH
Verifi es that inter-board communication sub-systems are
accessible and functional
Verifi es the switch matrix controller is accessible and functional
Verifi es that all the video channel sub-systems are accessible
and functional
Verifi es that the LAN connection is accessible and functional
Indicates the total number of currently connected and powered
AVRIQ modules
Indicates the number of AVRIQ modules that have been connected
successfully in the past and are apparently powered down
Indicates the number of AVRIQ modules that have been detected,
but are either unavailable for connection or have dropped packets
during the ping tests