Interfaces; Editing A Dtm Interface - Net Insight Nimbra One User Manual

Interfaces

Element Manager User's Manual Nimbra OneSerie
©2006 Net Insight AB, All rights reserved
The start web page for Interfaces, is presented in Figure 65.
Figure 65. DTM interfaces page
The table lists the DTM interfaces that are present in the unit. For each interface
the following is presented:
Name presents the name of the interface. The interface name, written as
" dtmX:Y" , where X is position of the card and Y position of the port, on the
card.
Capacity presents the total number of slots, which can be used.
Free shows the number of unused for transmit slots.
TX slots show the used slots i.e. from this node to the peering node.
TX capacity % column indicates the percentage of used slots in the transmit
direction. Each block is shown both as numbers and as a bar graph, representing
increments of 10%.
RX slots show the used slots for receive.
The RX capacity % column indicates the percentage of used slots for receive.
Each block is shown both as numbers and as a bar graph, representing
increments of 10%.

Editing a DTM interface

Access the DTM|Interfaces page. In the interface table, click on the Id of the
interface that should be edited. The Edit page, Figure 66, will appear.
DTM Configuration • 73