Date and time setting
Element Manager User's Manual Nimbra OneSerie
©2006 Net Insight AB, All rights reserved
3.
If Events should be logged tick the appropriate boxes and enter the Event
and Alarm log size.
4.
To make parameters active without leaving the page, click Apply. Any
changes will then be made effective immediately. To return to the
Maintenance page, click OK.
Restart the system
Note:
Save the configuration before restarting. Otherwise the
parameter changes will be lost! Refer to Configuration
handling.
1.
Navigate to web page Maintenance|System. The System page, Click on
restart or halt system at the top of page, Figure 17 , will appear. Type
Restart.
When the system is re-started the contact with the browser is lost. After a short
time, less than a minute, click on the "reload" button in the web browser to
connect again.
Figure 17. The Restart page
This section is intended to set and re-set the internal date and time clock of the
unit.
1.
Navigate to the Maintenance|Date & Time page, Figure 18, will appear.
Maintenance • 27