Configuration; Set The System Parameters; Set The Dtm Address - Net Insight Nimbra One User Manual

Configuration

20 • Quick Start Guide
©2006 Net Insight AB, All rights reserved
These procedures will set the basic parameters of the Nimbras. For a basic
configuration, keep the following information at hand:
Parameter name
System name
Location
Contact person
DTM address
Type definitions:

Set the System Parameters

1. Navigate to the Maintenance|System page, Figure 7 will appear.
Figure 7. The Maintenance, System page
2. Enter the System name, the name of the Contact person and the Location.
3. If Events should be logged tick the appropriate boxes and enter the Event
and Alarm log size.
4. To make parameters active without leaving the page, click Apply. Any
changes will then be made effective immediately. To return to the
Maintenance page, click OK.

Set the DTM address

1. Navigate to the web page DTM|Addresses and click on the Add address
button. The Add page, Figure 8, will appear.
Description
The name of the unit, to be used instead
of the IP address, for easier recognition
in the web page.
Description of the location of the unit.
The name or e-mail address of the
contact person for the unit.
Shows the DTM address of the node.
Man – mandatory, Rec – recommended, Opt – optional
Element Manager User's Manual Nimbra OneSerie
Type
Opt
Opt
Opt
Man